Recon 264150 - How To Replace H3 Bulb Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Recon 264150 - How To Replace H3 Bulb. RECON 264150 - How To Replace H3 Bulb User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 1
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
264150 Bulb Replacement HowTo Page 1
In This DIY I Will Explain How To Replace The H3 Bulb In RECON: Backup Projectors
Tools Required: Medium – Small, Sized Phillips Screwdriver
What You Need To Get:
New H# 55W Bulb
________________________________________________________________________________________
You Will First Need To Remove The Two Phillips Screws On The Side of Your
Recons. *NOTE The Order of The Washers. – Disconnect The Terminals.
Place Your Projector On A Solid Surface To Work On
Flip The Projector Upside Down – To Expose The Silver Access Plate
Remove The 3 Phillips Screws To Remove The Access Plate – Set Aside.
Examine How The Bulb Is Installed From The Factory
Remove The Screw Holding The Ground Terminal & The Bulb Keeper – Set Aside
Remove The Bad Bulb, Wiggle Back And Fourth Until Bulb Separates From The Housing
Install The New Bulb
Reassemble Following Tear Down Procedure.
The Ground and Power Wire Have Channels To Lay In
Be Sure The Cover Plate and Gasket Have A Good Seal, Be Sure Not To Over Tighten.
Visit Us Online at: www.GoRECON.com
Zobrazit stránku 0
1

Shrnutí obsahu

Strany 1 - What You Need To Get:

264150 Bulb Replacement How‐To Page 1 In This DIY I Will Explain How To Replace The H3 Bulb In RECON: Backup Projectors Tools Required: Medium – S

Komentáře k této Příručce

Žádné komentáře